/dev/sda === START OF INFORMATION SECTION === Model Family: Western Digital Blue Device Model: WDC WD5000AZLX-22JKKA0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 500,107,862,016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-3 T13/2161-D revision 3b SATA Version is: SATA 3.1, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Wed Nov 25 23:28:02 2020 GMT SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 5940) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 64) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x3035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 172 169 021 - 2383 4 Start_Stop_Count -O--CK 100 100 000 - 321 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 100 100 000 - 184 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 313 192 Power-Off_Retract_Count -O--CK 200 200 000 - 282 193 Load_Cycle_Count -O--CK 200 200 000 - 81 194 Temperature_Celsius -O---K 115 106 000 - 28 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 100 253 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 100 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb6 GPL,SL VS 1 Device vendor specific log 0xb7 GPL,SL VS 48 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) SCT Support Level: 1 Device State: Active (0) Current Temperature: 28 Celsius Power Cycle Min/Max Temperature: 28/28 Celsius Lifetime Min/Max Temperature: 14/38 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 478 (314) Index Estimated Time Temperature Celsius 315 2020-11-25 15:31 27 ******** ... ..( 12 skipped). .. ******** 328 2020-11-25 15:44 27 ******** 329 2020-11-25 15:45 28 ********* ... ..(120 skipped). .. ********* 450 2020-11-25 17:46 28 ********* 451 2020-11-25 17:47 29 ********** ... ..( 47 skipped). .. ********** 21 2020-11-25 18:35 29 ********** 22 2020-11-25 18:36 28 ********* ... ..( 31 skipped). .. ********* 54 2020-11-25 19:08 28 ********* 55 2020-11-25 19:09 29 ********** ... ..(116 skipped). .. ********** 172 2020-11-25 21:06 29 ********** 173 2020-11-25 21:07 28 ********* ... ..( 21 skipped). .. ********* 195 2020-11-25 21:29 28 ********* 196 2020-11-25 21:30 ? - 197 2020-11-25 21:31 20 * 198 2020-11-25 21:32 20 * 199 2020-11-25 21:33 21 ** 200 2020-11-25 21:34 ? - 201 2020-11-25 21:35 24 ***** 202 2020-11-25 21:36 ? - 203 2020-11-25 21:37 26 ******* 204 2020-11-25 21:38 ? - 205 2020-11-25 21:39 27 ******** 206 2020-11-25 21:40 ? - 207 2020-11-25 21:41 19 - 208 2020-11-25 21:42 19 - 209 2020-11-25 21:43 20 * 210 2020-11-25 21:44 20 * 211 2020-11-25 21:45 21 ** 212 2020-11-25 21:46 22 *** 213 2020-11-25 21:47 22 *** 214 2020-11-25 21:48 ? - 215 2020-11-25 21:49 24 ***** 216 2020-11-25 21:50 ? - 217 2020-11-25 21:51 25 ****** 218 2020-11-25 21:52 ? - 219 2020-11-25 21:53 25 ****** 220 2020-11-25 21:54 24 ***** 221 2020-11-25 21:55 24 ***** 222 2020-11-25 21:56 25 ****** 223 2020-11-25 21:57 25 ****** 224 2020-11-25 21:58 25 ****** 225 2020-11-25 21:59 ? - 226 2020-11-25 22:00 19 - 227 2020-11-25 22:01 ? - 228 2020-11-25 22:02 20 * 229 2020-11-25 22:03 20 * 230 2020-11-25 22:04 21 ** 231 2020-11-25 22:05 21 ** 232 2020-11-25 22:06 22 *** 233 2020-11-25 22:07 23 **** 234 2020-11-25 22:08 23 **** 235 2020-11-25 22:09 23 **** 236 2020-11-25 22:10 24 ***** 237 2020-11-25 22:11 24 ***** 238 2020-11-25 22:12 24 ***** 239 2020-11-25 22:13 25 ****** 240 2020-11-25 22:14 26 ******* ... ..( 9 skipped). .. ******* 250 2020-11-25 22:24 26 ******* 251 2020-11-25 22:25 27 ******** ... ..( 29 skipped). .. ******** 281 2020-11-25 22:55 27 ******** 282 2020-11-25 22:56 28 ********* 283 2020-11-25 22:57 28 ********* 284 2020-11-25 22:58 28 ********* 285 2020-11-25 22:59 ? - 286 2020-11-25 23:00 28 ********* ... ..( 27 skipped). .. ********* 314 2020-11-25 23:28 28 ********* SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 1745 Vendor specific